Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
GSR21-80 using 60J0001 Pulse Ingnition Control
LA
Member Posts: 1
It got a little chilly last night and my wife said turn on the furnace.
I set the thermostat to heat and it came on for 10 minutes. It locked itself out.
I had another controller so I hooked it up. It ran for about 10 minutes and the led went out on that one too.
I checked the pressure switch, replaced the air flapper, checked the intake and output piping.
Any thoughts?
I set the thermostat to heat and it came on for 10 minutes. It locked itself out.
I had another controller so I hooked it up. It ran for about 10 minutes and the led went out on that one too.
I checked the pressure switch, replaced the air flapper, checked the intake and output piping.
Any thoughts?
0
Comments
-
We have not abandoned you
I am looking to find my Lennox Pulse manuals so I can research the problem. I will get back to you.0
This discussion has been closed.
Categories
- All Categories
- 85.2K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 55 Biomass
- 424 Carbon Monoxide Awareness
- 72 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 129 Geothermal
- 160 Indoor-Air Quality
- 3.3K Oil Heating
- 60 Pipe Deterioration
- 878 Plumbing
- 5.9K Radiant Heating
- 375 Solar
- 14.6K Strictly Steam
- 3.2K Thermostats and Controls
- 58 Water Quality
- 49 Industry Classes
- 89 Job Opportunities
- 28 Recall Announcements