Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

PEX Question

Unknown
Unknown
in THE MAIN WALL
Multicor specifies 0.156 inches per ten degrees per hundred feet.

Comments

  • Roland_13
    Roland_13 Member Posts: 18
    PEX Question

    Hi All, Is there a linear expansion specification for 1/2" PEX-AL-PEX tubing? Thanks, Roland
  • Terry Trommeshauser
    Terry Trommeshauser Member Posts: 34


    Kitec shows exact same expansion rate. 0.156" per 10F-delta-t on 100ft run.
This discussion has been closed.

Categories