Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

Heat Pump

Options
Anthony Mobilio_3
Anthony Mobilio_3 Member Posts: 62
in THE MAIN WALL
Have an older lennox heat pump thermostat. The low voltage wires on the subase are all the same color black. Does anyone have a wiring diagram. The terminals have x,vr,b,f,m,e and L. The condenser is located on top of the roof. I was going to trace out each wire to see what was going where. It will same me a lot of time if anyone has any info on it. I know the f is fan, the x is common the e is emergency second stage heat stripes. The other terminals are in question. I think the m is powering the contactor. The b is the reversing valve, VR is power and L is hot for the light on the thermostat.

Thanks
Anthony

Comments

  • Glenn Harrison_2
    Glenn Harrison_2 Member Posts: 845
    Check out this link from Honeywell

    http://hbctechlit.honeywell.com/techlit/PDF/70-0000s/70-6627.pdf

    This is a PDF file of Honeywells Heat Pump Thermostat cross reference book. There are lots of wiring diagrams in there for converting Lennox T-stats to Honeywells. I'm sure there will be a diagram for you stat.

    This is a PDF file so you will need Adobe Acrobat Reader to open it. Also, it is 124 pages long so it will take a few minutes to download.

    Hope it helps. Glenn.
  • flange
    flange Member Posts: 153


    there should be a wiring diagram inside the blower compartment. this will easily allow you to figure out the wiring. they will go to a board in there and terminals should match.
This discussion has been closed.

Categories