Cut in a copper dwv fitting with little room
Comments
-
I have a good one for taking inside measurements but I'm confused as to how you can use one for level and plumb. You can make it straight vs something else but not level or plumb unless the other thing is one or the other.
Single pipe 392sqft system with an EG-40 rated for 325sqft and it's silent and balanced at all times.
0 -
i think that is the point, that you can't.
0 -
I agree, I carry one regularly. Offsets, bending, reading prints, scratching my back, pointing out others mistakes...the uses are endless. 50/50 solder was so much better, poison, but better.
0 -
yes on the 50 50
No on the B tank, just the little Mapp hand helds (we ran two for disassembly)
no finger licking- my finger tips know the drill
stick rule! Sorry I missed that generation. I recall the old dudes when I was getting into the trades in the early 80s. I though “man that’s kinda odd”
you must be old school too🇺🇸💯
0 -
Alan we gave it a flush and it was all dry- good enough!
0 -
@mattmia2 hmmmm I can’t think of any
0
Categories
- All Categories
- 87.9K THE MAIN WALL
- 3.3K A-C, Heat Pumps & Refrigeration
- 60 Biomass
- 430 Carbon Monoxide Awareness
- 133 Chimneys & Flues
- 2.2K Domestic Hot Water
- 6K Gas Heating
- 124 Geothermal
- 170 Indoor-Air Quality
- 3.9K Oil Heating
- 80 Pipe Deterioration
- 1.1K Plumbing
- 6.7K Radiant Heating
- 397 Solar
- 16.1K Strictly Steam
- 3.5K Thermostats and Controls
- 56 Water Quality
- 51 Industry Classes
- 51 Job Opportunities
- 18 Recall Announcements