Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
If our community has helped you, please consider making a contribution to support this website. Thanks!

Maybe its just me...

Options
Tom_133
Tom_133 Member Posts: 961
edited December 23 in THE MAIN WALL

So over the past year I have installed 10-12 GV90+ boilers, in different sizes. These are my go to boilers for lack of problems, and ease of repairs. They last, and typically give me very few issues.

Sadly though in those 10-12 I have replaced the rectifier plug, 591-391-985 on 4 of them. So I ordered 4 but many places seem to be out supplyhouse.com being one. You think it was a bad run of them?

Is it just me?

https://www.supplyhouse.com/Weil-Mclain-591-391-985-Wiring-Harness?srsltid=AfmBOorTGLKaq8YXD96rHwfIj6hvm5KuBdWfSkwQhP4yEig68OcPWbZz

Tom
Montpelier Vt
bjohnhy

Comments

  • kcopp
    kcopp Member Posts: 4,630

    It would Not be the 1st time a mfg supplier had a bad run of a part.

  • HomerJSmith
    HomerJSmith Member Posts: 2,710

    I have had a bad run with Honeywell and Comfortair, but they stood behind it. Ask Weil-Mclain tech support for the parts while explaining the problems to them. Remember, flattery will gets you everywhere.

  • 109A_5
    109A_5 Member Posts: 3,449

    You would have to figure out what part of it is actually failing. Rectifiers, bridge rectifiers and diodes in that size ballpark rarely go bad unless abused. I would suspect bad connections inside that molded assembly where you can't easily get to it or inspect it.

    National - U.S. Gas Boiler 45+ Years Old
    Steam 300 SQ. FT. - EDR 347
    One Pipe System
  • mattmia2
    mattmia2 Member Posts: 15,598
    https://forum.heatinghelp.com/discussion/comment/1878668#Comment_1878668

    or manufacture by the lowest bidder that isn't actually making sure they meet spec

Categories