Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

Steam kettle trap

Fritz_Kleiner
Fritz_Kleiner Member Posts: 2
in Strictly Steam

Any advice on what type of steam trap is best for a Groen jacketed steam kettle. I have a commercial kitchen with 5 40gal kettles that have F&T traps which work well. And 1 tilting 5 gal kettle that has a inverted bucket trap. This one doesn't seem to work as well.

Comments

  • Steamhead
    Steamhead Member Posts: 17,945

    Might not be a bad idea to replace the bucket trap with an F&T. Bucket traps don't vent air that well, and if the air can't get out of the kettle, the steam can't get in.

    All Steamed Up, Inc.
    Towson, MD, USA
    Steam, Vapor & Hot-Water Heating Specialists
    Oil & Gas Burner Service
    Consulting
    mattmia2Mad Dog_2
  • EBEBRATT-Ed
    EBEBRATT-Ed Member Posts: 18,453

    @Steamhead is right of course about the bucket trap

    What kind of steam pressure are you running?

    Most of the trap MFGS are all ok not much difference. I am partial to Watson-McDaniel but that is what our local pipe supplier sold.

    If you need specific advice Tunstall in Chicopee, MA is good with traps (you can google them)

    other than that

    Sarco

    Barnes & Jones

    Hoffman

    Armstrong

    ……….and the list goes on.

    Mad Dog_2
  • Fritz_Kleiner
    Fritz_Kleiner Member Posts: 2

    Thanks. System runs at 13psi. 2 months ago had a textbook perfect boiler fail. LWCO was'nt maintained and boiler ran dry, cracked the cast sections. Finally got a new Burnham boiler installed, and on startup ran cleaner chemical through the system. This must have disloged some crud, because when I took the Watson McDaniel bucket trap apart the air hole in the bucket was clogged. I assume that was my problem. Waiting for new seals to try it out again.

  • EBEBRATT-Ed
    EBEBRATT-Ed Member Posts: 18,453

    Do you get all the condensate return back to the boiler? Or do you lose some in the process? How much make up water do you use?

Categories