Hudson reed valve
does anyone have any experience with these Hudson reed valves for rads. The compression side is 16Mm. Seems pretty loose on 1/2 copper pipe. Just wondering if anyone has any experience with these and If 1/2” copper will work. Thanks
Comments
-
Not a plumber but you should probably plug your phone in before it dies completely.
Edward Young Retired
After you make that expensive repair and you still have the same problem, What will you check next?
0 -
what type of fitting is it? Does it have o ring seals and a crimp ring?
I have been able to get 1/2 copper into a 15 mm fitting by sanding the tube od a bit.
For the U.S. market Caleffi has this 437 fitting. I don’t know if it matches your valve. Recently they standardized that conical thread, across all the brands.
Bob "hot rod" Rohr
trainer for Caleffi NA
Living the hydronic dream0 -
it’s just a brass sleeve. Just seems loose on 1/2” copper.will look into the #437
0 -
a brass compression ferrule needs to be a snug fit or it may not bite into the tube. Not something you want to risk with water under pressure
Bob "hot rod" Rohr
trainer for Caleffi NA
Living the hydronic dream0
Categories
- All Categories
- 86.3K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 53 Biomass
- 422 Carbon Monoxide Awareness
- 90 Chimneys & Flues
- 2K Domestic Hot Water
- 5.4K Gas Heating
- 99 Geothermal
- 156 Indoor-Air Quality
- 3.4K Oil Heating
- 63 Pipe Deterioration
- 916 Plumbing
- 6K Radiant Heating
- 381 Solar
- 14.9K Strictly Steam
- 3.3K Thermostats and Controls
- 53 Water Quality
- 41 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements