Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Shimming recessed convector
Options
aat879
Member Posts: 17
I have a one-pipe steam system in my home, and all the heating sources are all convectors recessed in the wall behind a decorative cover. The convectors are encased in a thin metal housing. There’s a single convector that consistently experiences water hammer even after having the system serviced by the local steam pros. (I didn’t have them look at this convector because the cover was painted shut.) I was finally able to get the cover off to check level and found that it’s pitch every so slightly away from the pipe side. I want to shim it up a little, but the convector won’t seem to budge even though it doesn’t look like it’s fastened. Anyone have any tips? I’ve posted some pictures, but please let me know if other pics would be helpful.
0
Comments
-
-
Big Ed_4: Thanks. That occurred to me. Will any jack that fits (even a small car jack) work, or do they make a special jack for this sort of thing in tight spaces?0
-
Blocks of wood and a 2x4 will work . shove shims on the vent side shelf ....
There was an error rendering this rich post.
0
Categories
- All Categories
- 85.7K THE MAIN WALL
- 3K A-C, Heat Pumps & Refrigeration
- 51 Biomass
- 423 Carbon Monoxide Awareness
- 71 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 92 Geothermal
- 149 Indoor-Air Quality
- 3.2K Oil Heating
- 60 Pipe Deterioration
- 850 Plumbing
- 5.8K Radiant Heating
- 375 Solar
- 14.5K Strictly Steam
- 3.2K Thermostats and Controls
- 51 Water Quality
- 38 Industry Classes
- 55 Job Opportunities
- 18 Recall Announcements