Heat Transference Paste

Options
keye40
keye40 Posts: 1
in THE MAIN WALL
I am looking for Heat Transference Paste in a caulking gun tube. I need to inject it into a 1/2" conduit that is bent into a 90 on the side of a 9000 litre buffer tank. it goes in about 20 inches horizontally and drop about 15 inches vertically, these are in 5 location in the side of the buffer tank. At the end is the heat sensor. I need to inject about 3 inches of heat transfer paste in around the sensor. Can anyone give me any suggestions as to where I can buy it in caulking gun tubs?

Comments

  • hot_rod
    hot_rod Posts: 28,548
    I've only seen it in tubes, syringe or cans. You can buy empty caulk gun tubes and load from a can.
    Bob "hot rod" Rohr
    trainer for Caleffi NA
    Living the hydronic dream
  • mattmia2
    mattmia2 Posts: 18,254
    You could also get a bulk caulk gun or use a caulk gun to drive a syringe
    keye40
  • Larry Weingarten
    Larry Weingarten Posts: 4,205
    Hi, Another approach would be to get a grease gun, hook up a skinny hose to it and push that hose down to the end of your sensor well to apply the paste.

    Yours, Larry
    keye40
  • EdTheHeaterMan
    EdTheHeaterMan Posts: 12,880
    I have noticed a similarity with Anti- Seize compound and heat transfer paste. how similar are they? If they are close could this product work?
    https://www.antiseize.com/18015

    Edward Young Retired

    After you make that expensive repair and you still have the same problem, What will you check next?

Categories