Click here to Find a Contractor in your area.
Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
IBC Boiler fails

I am interested to hear other people's experiences with IBC BOILERS as a result of the dangerous issues that we have faced. Carbon Monoxide was pumped into our home over a period of nine months, after the new boiler was installed. Installer couldn't figure it out - exhaust lines extended so that there wasn't a re circulation of exhaust. Power supply was addressed (battery backup installed) and that wasn't the issue. The efficiency was tuned down (so much for high efficiency). That wasn't the issue. Finally the manufacturer admitted the problem was widespread - a faulty processor. Fire Department was called out TWICE to our home. Now its only a year later (two years after install) and the heat exchanger goes. IBC says not a warranty issue because our system - which had been purged prior to install, wasn't clean enough. Clearly this is not a good choice for a home, or as a replacement boiler. We don't trust it and are wondering if we bite the bullet and rip it out and install something else? A Lennox? Interested in other experiences.
0
Leave a Comment
Categories
- 80.9K THE MAIN WALL
- 2.5K A-C, Heat Pumps & Refrigeration
- 36 Biomass
- 394 Carbon Monoxide Awareness
- 2.6K Controls
- 1.4K Domestic Hot Water
- 3.7K Gas Heating
- 101 Geothermal
- 130 Indoor-Air Quality
- 2.3K Oil Heating
- 30 Pipe Deterioration
- 565 Plumbing
- 4.2K Radiant Heating
- 333 Solar
- 12.1K Strictly Steam
- 36 Water Quality
- 7 Industry Classes
- 51 Job Opportunities
- 7 Recall Announcements
Comments
We've had pretty good luck with them. We had to replace the ignition module once, but not because of CO problems. I don't understand how a processor problem could lead to CO in the living space. Whatever CO is produced should go out the flue.
The HX problem is another problem. Do you have a cast iron radiator system? If so and without some kind of filter, iron oxide could have taken out the HX.
The reason I continue with IBC is their tech support which is very good and they have a local rep. that stocks all replacement parts.
Click here to learn more about this contractor.
The previous boiler was cast iron. We did a purge prior to the install of this new boiler. When we contacted IBC about the warranty - they first suggested we had Poly B lines (we don't), and then when they did their investigation, simply told us our fluid must be the issue. So we have paid the price for the new HX (learning the lingo!!), and will now pay for another fluid flush. It would have been helpful if we knew how important it was for the system to be remain extremely clean. Likely not a good replacement option as it feels like we have installed a high tech sports car - expensive to purchase and expensive to maintain.
With so much cost and so little reliability in the two years we have owned the product, we are considering if it is worth it to rip it out and replace with a different product that might have fewer features but be the workhorse we would prefer.
You should re-post in the Gas Heating forum or ask Erin (the administrator) to move you.
Click here to learn more about this contractor.
I've seen a lot of customers over the years regret the decision to replace a cast iron boiler with a mod con. Most people find that reliability, ease of service durability are more important than efficiency.