Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

Ridged threaders

Options
Hibernation_Heating
Hibernation_Heating Member Posts: 9
in Plumbing
I have a ridged 4-p threader. Do they seriously not make teeth anymore for these things

Comments

  • Intplm.
    Intplm. Member Posts: 1,949
    Options
    What has brought you to the assumption that they do not make the dies, or teeth any longer?
    Have you contacted Ridgid tool tech support to find that information? Call them to put any misinformation aside.

    1-800-4RIDGID
  • EBEBRATT-Ed
    EBEBRATT-Ed Member Posts: 15,524
    Options
    @Hibernation_Heating

    Not 100% sure but if your talking about a Ridgid 4PJ I think you are correct.
  • hot_rod
    hot_rod Member Posts: 22,142
    Options
    Check on e bay
    Bob "hot rod" Rohr
    trainer for Caleffi NA
    Living the hydronic dream
  • Hibernation_Heating
    Hibernation_Heating Member Posts: 9
    Options
    I did buy a used 3” die set. Good ol EBay.
    It just surprises me that with the popularity of these that there are no new ones for sale. I will check with ridgid though. Maybe they’re just special order and not advertised
  • EBEBRATT-Ed
    EBEBRATT-Ed Member Posts: 15,524
    Options
    @Hibernation_Heating

    If my memory is correct Ridgid also makes the model #141
    2 1/2"-4" & the #161 4"?-6"

    The 141 replaces the 4PJ threader.

    Unfortunately I threw away a Toledo #2 2 1/2"-6" and a Toledo 41E 2 1/2"-4" couldn't find dies for either one of them looked on E-Bay for years so I finally tossed them. Toledo was bought out by Curtis air compressor and they finally dropped everything.

Categories