Click here to Find a Contractor in your area.
Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.

Two questions on BB accessories

sunlight33
sunlight33 Member Posts: 311
edited January 2019 in THE MAIN WALL
1. I have a 14 ft BB run in one room, can I add this coupling in the middle for thermal expansion: https://www.supplyhouse.com/Raven-R1644-3-4-x-6-Coupling-x-Coupling-Baseboard-Connector#reviews-content

2. What's a good accessory for purging air in BB? I found this but not looking heavy duty, wonder if it will develop any leak in the future: https://www.pexuniverse.com/3-4-c-x-1-8-mpt-x-3-4-c-cast-brass-baseboard-tee-with-vent-cap
My LLH has an air bleeder valve but it's located about 4 feet below BB on the second floor of the house, not sure if this is enough to do the job or I need to add one to the BB. Thanks!

Comments

  • STEVEusaPA
    STEVEusaPA Member Posts: 4,964
    1. It may work, but sometimes the noise is from the baseboard rubbing the bracket, or a pipe rubbing at a penetration, in which case this wont help.
    2. Proper piping (pumping away) with well placed valve(s) and drain(s) will allow you to purge almost all the air in the basement, and a proper air eliminator (if you have a bladder tank and not a steel expansion tank) will take care of the rest.
    If you use that elbow, you'll end up putting on one of the cheapest devices around, a hy vent. You can't use it with a steel expansion tank. It will eventually leak/fail and become useless, and you'll be draining down the system to replace it (unless you have the room to put a small shut off on it.
    steve
  • NY_Rob
    NY_Rob Member Posts: 1,370
    edited January 2019
    You could use a baseboard Tee with a 1/8" FPT and a Coin Vent. It would be easier to control vs. that brass cap.

    https://www.pexuniverse.com/3-4-c-x-1-8-fpt-x-3-4-c-cast-brass-baseboard-tee

    https://www.supplyhouse.com/Taco-417-3-Coin-Vent-11389000-p
  • sunlight33
    sunlight33 Member Posts: 311
    edited January 2019
    Thanks, never seen that before, guess I am very new to hydronics.
    This can be placed on either the supply side or the return side right? Because I can't figure out which end of the BB is which, lol!
    Also if all BB are connected in series, I just need to place one on any of them, right?
Sign In or Register to comment.

Welcome

It looks like you're new here. If you want to get involved, click one of these buttons!