Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Crossover Traps
Options
Sailah
Member Posts: 826
I had a request to make some high capacity crossover traps to compete with an unobtanium Nicholson trap. Recently I had another few inquiries so rather than make it an "in the know" part I'd share it if anyone is looking for one.
I made them using the same body as the Big Mouth but they are not o-ringed. Machined brass seat with same 5/8" orifice to provide maximum capacity.
Since the body was originally 3/4" NPT I face bush the outlet with a 1/2" bushing and red loctite it. The tailpiece is a special 1/2" NPT tailpiece. So it's kinda like a fat man in little suit to quote Chris Farley. Can also do this in 3/4" if needed.
Working pressure Vac-25 PSIG
I made them using the same body as the Big Mouth but they are not o-ringed. Machined brass seat with same 5/8" orifice to provide maximum capacity.
Since the body was originally 3/4" NPT I face bush the outlet with a 1/2" bushing and red loctite it. The tailpiece is a special 1/2" NPT tailpiece. So it's kinda like a fat man in little suit to quote Chris Farley. Can also do this in 3/4" if needed.
Working pressure Vac-25 PSIG
Peter Owens
SteamIQ
SteamIQ
4
Comments
-
And it is an awesome venter!gwgillplumbingandheating.com
Serving Cleveland's eastern suburbs from Cleveland Heights down to Cuyahoga Falls.0
Categories
- All Categories
- 85.7K THE MAIN WALL
- 3K A-C, Heat Pumps & Refrigeration
- 49 Biomass
- 418 Carbon Monoxide Awareness
- 72 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 92 Geothermal
- 149 Indoor-Air Quality
- 3.2K Oil Heating
- 59 Pipe Deterioration
- 848 Plumbing
- 5.8K Radiant Heating
- 371 Solar
- 14.5K Strictly Steam
- 3.2K Thermostats and Controls
- 50 Water Quality
- 39 Industry Classes
- 47 Job Opportunities
- 15 Recall Announcements