Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

Left hand thread Steam Rad Bushing

JimRafferty
JimRafferty Member Posts: 21
in Strictly Steam
Desperately seeking an 1-1/2" left hand threaded x 1" right thread bushing for an old steam rad.
It's a tight fit and the left/right nipple approach is a last, last resort.
I'm In the Phila area and appreciate any and all suggestions for sources.

Comments

  • JohnNY
    JohnNY Member Posts: 3,195
    When we can't find a left-hand-thread bushing we screw in a L-R nipple and take it from there.
    Contact John "JohnNY" Cataneo, NYC Master Plumber, Lic 1784
    Consulting
    Plumbing in NYC or in NJ.
    Take his class.
  • nicholas bonham-carter
    nicholas bonham-carter Member Posts: 8,575
    Probably those left hand threaded pieces are available from McMaster-Carr.--NBC
  • Gordo
    Gordo Member Posts: 842
    I have a 1-1/2" left-hand/right-hand internal radiator nipple. End-to-end length is 1-1/8". Will that do?
    All Steamed Up, Inc.
    "Reducing our country's energy consumption, one system at a time"
    Steam, Vapor & Hot-Water Heating Specialists
    Oil & Gas Burner Service
    Baltimore, MD (USA) and consulting anywhere.
    https://heatinghelp.com/find-a-contractor/detail/all-steamed-up-inc
  • JimRafferty
    JimRafferty Member Posts: 21
    Thanks Gordo, but I'm dealing with a bank of wall hung rads that are very close together. If we go with anything but a bushing, we'll have to remove and rehang the whole mess. However, I am getting closer. Shafter Bros. in Montreal carries a !-1/2" left x 3/4" right bushing. Thanks again, Wallies!

Categories