Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
If our community has helped you, please consider making a contribution to support this website. Thanks!
Hydro Level VXT - Can it be used on larger commercial boilers?
Options
Steve_210
Member Posts: 664
I've used these on smaller residential boilers with great success. Do you guys use them on the larger commercial? If not, I can always use a small water meter. This particular boiler is 810,000 BTUs. Any help greatly appreciated
0
Comments
-
I used one a few years ago on a peerless 1.4 mbtu with no issues and quite a few on boiler pretty close to your size .Great product but it still does not take the place of some taking alook every week .I usually set them for a slow feed (gpm)and a long delay like to give the condensate time to come back and also if there doin big set backs .Hate seeing a flooded boiler and get the call of water hammer and find her flooded .Peace and good luck clammy
R.A. Calmbacher L.L.C. HVAC
NJ Master HVAC Lic.
Mahwah, NJ
Specializing in steam and hydronic heating5 -
Thanks clammy that's a great help great.
Peace.0 -
These auto feeds should be valved off at least for the first week, or until after the skimming, so that any leaks can be seen.0
Categories
- All Categories
- 87.3K THE MAIN WALL
- 3.2K A-C, Heat Pumps & Refrigeration
- 61 Biomass
- 429 Carbon Monoxide Awareness
- 120 Chimneys & Flues
- 2.1K Domestic Hot Water
- 5.8K Gas Heating
- 115 Geothermal
- 166 Indoor-Air Quality
- 3.7K Oil Heating
- 77 Pipe Deterioration
- 1K Plumbing
- 6.5K Radiant Heating
- 395 Solar
- 15.7K Strictly Steam
- 3.4K Thermostats and Controls
- 56 Water Quality
- 51 Industry Classes
- 50 Job Opportunities
- 18 Recall Announcements