Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Using two Burnham pv4 boilers
TonyS
Member Posts: 849
to replace existing boiler. I would like to abandon the chimney and use power vent boilers. Unfortunately Burnam does not make a 7 section in PV.
What would be a good control to stage these boilers?
Would staging two boilers like this be a good idea?
Would it save the customer money on fuel?
All ideas and opinions greatly appreciated. Thanks
What would be a good control to stage these boilers?
Would staging two boilers like this be a good idea?
Would it save the customer money on fuel?
All ideas and opinions greatly appreciated. Thanks
0
Comments
-
Boilers
Stay tuned to my thread titled "1930's VECO Vapor System". I'm installing a tandem steam system and will list all of the controls used.
We're staging the boilers with a 2-stage thermostat and Vaporstats. We expect major savings. Around 50%.0
This discussion has been closed.
Categories
- All Categories
- 85.2K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 55 Biomass
- 424 Carbon Monoxide Awareness
- 72 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 129 Geothermal
- 160 Indoor-Air Quality
- 3.3K Oil Heating
- 60 Pipe Deterioration
- 878 Plumbing
- 5.9K Radiant Heating
- 375 Solar
- 14.6K Strictly Steam
- 3.2K Thermostats and Controls
- 58 Water Quality
- 49 Industry Classes
- 89 Job Opportunities
- 28 Recall Announcements