What are the flow rates coming out of this Tee?
Options
Eastman
Posts: 1,002
If flow z = 6gpm, what does x and y equal?
flow x = ?
flow y = ?
The 3/4 inch side loops are equal in every way. (length, elbows, etc...)
Yes, the question is as simple as it seems.
flow x = ?
flow y = ?
The 3/4 inch side loops are equal in every way. (length, elbows, etc...)
Yes, the question is as simple as it seems.
0
Comments
-
Ummm...
Forgot to study last night....Hmmm. It's coming to me....Let me think.... 3!There was an error rendering this rich post.
0 -
I need some else though
I need more than one opinion.0 -
I belive the ole
What goes into a tee must come out rule applies here. So 3.0 -
flow rate
since both loops [x,y] are equal, then the flow must be the same in each.
due to the incompressibility of water, then the flow will be 3gallons in each.--nbc0 -
Thanks
That should be good.0 -
Yes, 3!
Don't get flow rate confused with velocity.0
This discussion has been closed.
Categories
- All Categories
- 87.9K THE MAIN WALL
- 3.3K A-C, Heat Pumps & Refrigeration
- 60 Biomass
- 430 Carbon Monoxide Awareness
- 134 Chimneys & Flues
- 2.2K Domestic Hot Water
- 6K Gas Heating
- 124 Geothermal
- 170 Indoor-Air Quality
- 3.9K Oil Heating
- 80 Pipe Deterioration
- 1.1K Plumbing
- 6.7K Radiant Heating
- 397 Solar
- 16.1K Strictly Steam
- 3.5K Thermostats and Controls
- 56 Water Quality
- 51 Industry Classes
- 52 Job Opportunities
- 18 Recall Announcements



