What is this fitting?
Options
STEVE PAUL_3
Posts: 126
My son's co-op apartment in Brooklyn had a major re-modeling done 5 years back. The fitting shown in the attachment was used as the washing machine drain standpipe trap, inside the wall. I cannot identify it. I have not been on the site to see it. Does anyone recognise it? what are the tapping sizes? I suspect that this is some sort of a heating fitting that was jury rigged to be used as a trap. The number 9A makes me think Burnham cast Iron baseboard. Any ideas?
0
Comments
-
Drum Trap
Thats an old drum type trap, it is not a heating fitting. They're common on old washing machine waste connections.0
This discussion has been closed.
Categories
- All Categories
- 87.9K THE MAIN WALL
- 3.3K A-C, Heat Pumps & Refrigeration
- 60 Biomass
- 430 Carbon Monoxide Awareness
- 135 Chimneys & Flues
- 2.2K Domestic Hot Water
- 6K Gas Heating
- 124 Geothermal
- 170 Indoor-Air Quality
- 3.9K Oil Heating
- 80 Pipe Deterioration
- 1.1K Plumbing
- 6.7K Radiant Heating
- 397 Solar
- 16.2K Strictly Steam
- 3.5K Thermostats and Controls
- 56 Water Quality
- 51 Industry Classes
- 51 Job Opportunities
- 18 Recall Announcements