Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

New header please comment

Options
Timco
Timco Member Posts: 3,040
Well, here it is. I moved the LWCO to the front from the side, and added a manual reset LWCO as well. It used to have just one pipe to the main, no header. Decided to go 3" on equalizer.



Tim
Just a guy running some pipes.

Comments

  • Norm Harvey
    Norm Harvey Member Posts: 684
    Options
    Looks Great!

    Looks great tim!   ou could use a healthier lunch though!
    "We see the world as WE are, not as IT is, because it is the "I" behind the EYE that does the seeing"
  • I think it`s great too Tim,,,

    I`m a little lost though,,, what was the cherry-picker for?

    I thought you were re-piping the header.
  • Steamhead
    Steamhead Member Posts: 16,835
    Options
    Looks real good to me

    the only thing I would have done differently was to have dropped the header. How does the system run now that the boiler is properly piped?  
    All Steamed Up, Inc.
    Towson, MD, USA
    Steam, Vapor & Hot-Water Heating Specialists
    Oil & Gas Burner Service
    Consulting
  • Timco
    Timco Member Posts: 3,040
    Options
    thanks!

    I considered dropping the header, but didn't think it needed it given the improvements. I took these pics today, still a bit of piping to go. The engine picker was to lift one end at a time and move it several feet from the wall so I could pour a level pad, then use a come-along to move it back up onto the pad with 1" pipe cut into rollers. It ws just sitting in the corner on a very sloped portion of the floor near a drain.



    Tim
    Just a guy running some pipes.
  • Good call Tim,,

    I hope someone like the GOVERNATOR was there to help you?

    Those 4 footers & compound wrenches do take their toll on the body ,,,, eventually.  ;-)
This discussion has been closed.