Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Pressuretrol Settings
Options
Marc_3
Member Posts: 9
This may be a stupid question, but please humor me.
My 1-pipe system has a PA404A pressuretrol. The cut-in is all the way down. I'd like to check the differential, as I think my system pressure is too high (boiler runs for a long time and doesn't shut down after all rads are hot until thermostat shuts it.)
How do I open the pressuretrol to check it? I was reluctant to just take the screw out of the front in case I wasn't supposed to.
Thanks.
My 1-pipe system has a PA404A pressuretrol. The cut-in is all the way down. I'd like to check the differential, as I think my system pressure is too high (boiler runs for a long time and doesn't shut down after all rads are hot until thermostat shuts it.)
How do I open the pressuretrol to check it? I was reluctant to just take the screw out of the front in case I wasn't supposed to.
Thanks.
0
Comments
-
Screw
Take out that screw and set yourself free. You're a steam guy now.
Anthony Menafro0
This discussion has been closed.
Categories
- All Categories
- 85.7K THE MAIN WALL
- 3K A-C, Heat Pumps & Refrigeration
- 51 Biomass
- 423 Carbon Monoxide Awareness
- 71 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 92 Geothermal
- 149 Indoor-Air Quality
- 3.2K Oil Heating
- 59 Pipe Deterioration
- 850 Plumbing
- 5.8K Radiant Heating
- 371 Solar
- 14.5K Strictly Steam
- 3.2K Thermostats and Controls
- 51 Water Quality
- 38 Industry Classes
- 55 Job Opportunities
- 18 Recall Announcements