Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

Auto mag zone valves

Maine Ken
Maine Ken Member Posts: 531
Auto Mag are powered closed. When their is a power loss they open. Used for wood boilers around here to go to a dump zone.

<A HREF="http://www.heatinghelp.com/getListed.cfm?id=346&Step=30">To Learn More About This Professional, Click Here to Visit Their Ad in "Find A Professional"</A>

Comments

  • nick z.
    nick z. Member Posts: 157
    Auto mag zone valves

    I inherted this job, has existing "Auto mag Zone valves. Anybody ever hear of these? All they say on them is "auto mag". House was moved and jacked up after being flooded.Someone got as far as ahving to re-install zone valves and start heat and then left the job.The people are living there with out heat. I'm going to work there tomorrow, try to get them heat. Any help would be appreciated. Happpy Thanksgiving!
  • bob_46
    bob_46 Member Posts: 813
    Automag's

    are also 24volt DC.

    There was an error rendering this rich post.

  • Alan R. Mercurio_3
    Alan R. Mercurio_3 Member Posts: 1,624


    Here's someone that may be able to help you out.

    Automag

    Jim Specht

    1-800-451-2002


    Jim’s E-mail: jspecht@c1mail.com


    Your friend in the industry,
    Alan R. Mercurio

    To Learn More About This Professional, Click Here to Visit Their Ad in "Find A Professional"

    There was an error rendering this rich post.

  • nick z.
    nick z. Member Posts: 157
    Thanks

    everyone,Happy Thanksgiving
  • Mike L
    Mike L Member Posts: 30
    Automags

    are a nice little zone valve they are 24 volt DC.I preffer to use their ZVC which I think takes all of the work out of all zone valves,that allows you to use ordiary every day t-stats instead of their cheap snap action or cooling t-stats.However they are a quick acting or snap action zv and can hammer if not installed in the right spot.
This discussion has been closed.