Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

Who made this???

Maine Ken
Maine Ken Member Posts: 531
I stumbled across a "Circle Cumbustion" boiler today. I need a gasket for it. The only info is the name. It is a canary yellow, it is a scotch marine design, and it has a companion canary yellow indirect. The Boiler, indirect and Riello 5m all say "Circle Combustion".

Does anyone know who made/ makes this???

"Maine" Ken

Comments

  • J.C.A._3
    J.C.A._3 Member Posts: 2,981
    Those were,

    A re-badged boiler and water heater. In our area, they were installed by GlenMor fuel company. They are now owned by Petro.

    Most of the boilers I saw were Italian in design and made by Calortechnica. The water heaters were painted beige but made by Amtrol. Hope this helps.If not, might I suggest contacting Firedragon Ent.. George had a hand in their training dept. at around that time, I believe. If your looking for the flange gasket that connects the metric to American thread, try Bell Pump. They used to use the same flange on Pensotti boilers back in the day. Good luck. Chris
  • Maine Ken
    Maine Ken Member Posts: 531


    The indirect sure does look like an Amtrol!. Thanks alot.

    Bell Pump doesn't carry Pensotti around here. I will check with Steve Cole from PNA. I am looking for the gasket that seals the front panel.

    I also need a new aquastat well. This one is situated on top of the boiler, near the back and it appears to be attatched using flanges. Is there anything special about this well????
  • Robert O'Connor_6
    Robert O'Connor_6 Member Posts: 299
    Yeah Ken

    I think they are a Pensotti too . I got involved in one of these in Falmouth a long time ago. Bell Pump sold Pensotti back then.

    Contact the folks at Pensotti North America. PNA in Bangor

    942 36 36 Cell 478 6886.


    All the best

    Robert

    ME
  • Maine Ken
    Maine Ken Member Posts: 531


    Thanks Robert, Steve is in Boston for a few days. I'll get him on his cell.

    Hope all is well in LA!!!
  • Firedragon_4
    Firedragon_4 Member Posts: 1,436
    It's a Pensotti and

    you'll have to cut the gasket yourself from non-asbestos board. I have North American boiler #1 here in the lair and she's still going strong!

    BTW, the indirect is an Amtrol, but no warranty from them or Pensotti or Riello since all warranties were handled by Whaleco/Circle who is now kaputski!
  • Maine Ken
    Maine Ken Member Posts: 531


    Is there anyplace to get a manual????
  • J.C.A._3
    J.C.A._3 Member Posts: 2,981
    Ken,

    Try over at Oil Tech Talk. Go to the "Just For Teks" section. I think there might be something in there from Mr. Gates old archives. Chris
This discussion has been closed.