Steam Radiation

Steve_13

Need some help with this guys.
Surveved a church today for updating the mechanicals and found something I've never seen before. We've got a cast iron heating coil inside an air handler with no markings ther than an ID tag on the cabinet stating "Manufactured for A.M.Castle &Co.--Chicago, IL." This thing is 17 sections wide 2 sections deep(34 sections total), each section being 10inches wide,72inches high & approx. 5inches deep. Anyone have any idea on the amount of EDR or how to figure the same? Thanks in advance.
Steve

Ken_8

Send us a picture

And provide some dimensions. Stuff like the supply piping diameter, the return, vent setup, etc.

How about a tag? Look real closely on a frame under a door, the castings may have markings - a logo, anything that would help us. If this bad boy resides in a plenum, the inlet and discharge duct/plenum sizing may be beneficial.

To Learn More About This Professional, Click Here to Visit Their Ad in "Find A Professional"

paul lessard_3

EDR

Check page 109 I'll guess it's 1100SF

To Learn More About This Professional, Click Here to Visit Their Ad in "Find A Professional"

Steve_13

Thanks Ken & Paul. I'll attempt to get pictures and more info, but it will not be until next week as I'm not in town tomorrow.

Steve_13

Thanks Ken & Paul. I'll attempt to get pictures and more info, but it will not be until next week as I'm not in town tomorrow.