Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
P/S Loops
Paul_28
Member Posts: 113
Is it recommended or necessary to disassemble plumbing components when soldering?
In the WM instruction manual for the Ultra Boiler the Make UP Supply and Expansion Tank are shown in the Secondary Piping. Can they be placed in the primary loop?
In the WM instruction manual for the Ultra Boiler the Make UP Supply and Expansion Tank are shown in the Secondary Piping. Can they be placed in the primary loop?
0
This discussion has been closed.
Categories
- All Categories
- 86.5K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 53 Biomass
- 423 Carbon Monoxide Awareness
- 96 Chimneys & Flues
- 2K Domestic Hot Water
- 5.5K Gas Heating
- 101 Geothermal
- 157 Indoor-Air Quality
- 3.5K Oil Heating
- 64 Pipe Deterioration
- 928 Plumbing
- 6.1K Radiant Heating
- 384 Solar
- 15.1K Strictly Steam
- 3.3K Thermostats and Controls
- 54 Water Quality
- 42 Industry Classes
- 48 Job Opportunities
- 17 Recall Announcements