Werks in Progress-PGP

Paul Pollets_2

Just finished the near-boiler piping on a project on Vashon Island, near Seattle. It's nice to get out of the city (by Ferry) and disappear into the country. The system will heat the residence with RFH and 3 Towel Bar Rads, the deck around the indoor lap pool, the pool itself, with a FPHX and the Garage guest rooms with 3 Wall Panel Rads. The mechanical room is in the garage and we used Ecoflex underground distribution for all the heating mains and potable water. The Vitola 200 boiler will use a Riello burner until the new "Blue Flame" chassis burners are shipped. Also used a Vitocell 300-79g DHW tank and the Vitotronic 200 computer. We'll also do the pool dehumidification with a Lifebreath 200 MAX.

<A HREF="http://www.heatinghelp.com/getListed.cfm?id=104&Step=30">To Learn More About This Contractor, Click Here to Visit Their Ad in "Find A Contractor"</A>

heatboy

Nice, Paul!

Another burner change. Just when I start to get the hang of the Chassis burner............. What size boiler is that and where will the pool mechanicals be?

I wish someone around here carried Ecoflex. It would save quite a bit of time. Where do you get those cool unistrut end caps?

hb

To Learn More About This Contractor, Click Here to Visit Their Ad in "Find A Contractor"

Paul Pollets_2

details

Ecoflex is now stocked in smaller pieces around the country so wholesalers can make room for it. Try my friend Larry Ackelson lackelson@ecoflexna.com for the answer. The strut end caps are from B-Line, The pool mechanicals will be next to the lap pool, about 90ft from the garage. The Vitola is a #33.
Hope you're well...see ya at HCT!
Paul

To Learn More About This Contractor, Click Here to Visit Their Ad in "Find A Contractor"

Mark J Strawcutter

end caps

I think unistrut makes them, too.

http://www.unistrut.com/pdf/General_14/S02_channel.pdf

pdf page 40, catalog page 60

Mark