Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

hey HydronicsMike

Leo G_57
Leo G_57 Member Posts: 5
in THE MAIN WALL
send me your e-mail addy, i can't find it anymore, and have a question regarding a control set-up!

thanx!!

leo


a_aardvarkplumbing@hotmail.com

Comments

  • Unknown
    Unknown
    Hey Leo

    Here is Mike's e-mail address. Hope this helps.

    Glenn

    hydronicsmike@canada.com
  • hydronicsmike
    hydronicsmike Member Posts: 855
    Thanks Glenn.

    Looking forward to hearing from you Leo.

    Mike
  • hydronicsmike
    hydronicsmike Member Posts: 855
    Leo

    I just checked my email. Nothing there...yet;)

    Mike
  • Leo G_57
    Leo G_57 Member Posts: 5
    hey glenn

    am going to be ordering 4 slenderized cast rads in the next couple of days, what distance should i allow from the sides of the rads for my rough-in piping?

    thanx!!!

    leo
  • Unknown
    Unknown
    That may vary Leo

    Depending on whether you are using them for hot water or steam and may differ from one valve manufacturer to another. I would advise having the valves in hand first. Hope this helps.

    Glenn
  • Leo G_57
    Leo G_57 Member Posts: 5
    t hanx glenn

    have not been given time to figure out the valves yet, so i guess i'll just keep my supply and returns low enough to do an offset if needed!

    leo
This discussion has been closed.

Categories