Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Taco 007 IFC
Mark Hunt
Member Posts: 4,908
have problems with these?
I fired up a new install yesterday with three 007 IFC's and two of them SCREAMED when we activated them.
I thought they were siezed until I pulled the cartridge and proved that they were not. I pushed the flow check device into the groove and the pumps ran fine.
Anyone else experience this?
TIA
Mark H
<A HREF="http://www.heatinghelp.com/getListed.cfm?id=238&Step=30">To Learn More About This Contractor, Click Here to Visit Their Ad in "Find A Contractor"</A>
I fired up a new install yesterday with three 007 IFC's and two of them SCREAMED when we activated them.
I thought they were siezed until I pulled the cartridge and proved that they were not. I pushed the flow check device into the groove and the pumps ran fine.
Anyone else experience this?
TIA
Mark H
<A HREF="http://www.heatinghelp.com/getListed.cfm?id=238&Step=30">To Learn More About This Contractor, Click Here to Visit Their Ad in "Find A Contractor"</A>
0
Comments
-
yup i did
they settled down after a day and no problems since!!
Murph'0
This discussion has been closed.
Categories
- All Categories
- 86.5K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 53 Biomass
- 423 Carbon Monoxide Awareness
- 95 Chimneys & Flues
- 2K Domestic Hot Water
- 5.5K Gas Heating
- 101 Geothermal
- 156 Indoor-Air Quality
- 3.5K Oil Heating
- 64 Pipe Deterioration
- 928 Plumbing
- 6.1K Radiant Heating
- 384 Solar
- 15.1K Strictly Steam
- 3.3K Thermostats and Controls
- 54 Water Quality
- 41 Industry Classes
- 48 Job Opportunities
- 17 Recall Announcements