Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Self Feed Drill?
JimmyJam
Member Posts: 78
I have (2) joist heating jobs coming up and would like input on types of self feed drills recommended. I normally use Wirsbo pex clips but also use Joist Trak. I have found limitations as to the length of screws most guns drive. I have determined that I will need a maximum 3/4" for joist Trak and 1" for pex clips? The heads on most drills I've found do not seem to permit enough depth for the clips. Any recommendations?
Thanks!
Thanks!
0
This discussion has been closed.
Categories
- All Categories
- 86.7K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 61 Biomass
- 423 Carbon Monoxide Awareness
- 104 Chimneys & Flues
- 2K Domestic Hot Water
- 5.6K Gas Heating
- 103 Geothermal
- 158 Indoor-Air Quality
- 3.5K Oil Heating
- 68 Pipe Deterioration
- 939 Plumbing
- 6.2K Radiant Heating
- 385 Solar
- 15.3K Strictly Steam
- 3.4K Thermostats and Controls
- 54 Water Quality
- 43 Industry Classes
- 47 Job Opportunities
- 18 Recall Announcements