Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Approved PEX for BB lines?
anthony_7
Member Posts: 72
I am wondering if someone makes a PEX product I can run for new heating purposes to BB. I am doing a new upstairs and might look into this instead of copper. Just curious what would handle the temp?
0
Comments
-
Any type of PEX
will do. Use Pex-Al-Pex for more rigidity.0 -
PEX for baseboard
Use it all the time, but be careful. Check manufacturers sizing charts for total length and max. feet of board.
5/8" PEX is about as large as you can use without too much effort and it won't carry the same load as 3/4" copper will.
It's a real time saver, but the connecting fitting are more expensive that copper 90s.
To Learn More About This Contractor, Click Here to Visit Their Ad in "Find A Contractor"0 -
and the highest heat rating too!
Kitec is good stuff!0 -
Don't forget to use only oxygen barrier tube
if you want to keep things clean.0
This discussion has been closed.
Categories
- All Categories
- 86.3K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 53 Biomass
- 422 Carbon Monoxide Awareness
- 90 Chimneys & Flues
- 2K Domestic Hot Water
- 5.4K Gas Heating
- 100 Geothermal
- 156 Indoor-Air Quality
- 3.4K Oil Heating
- 64 Pipe Deterioration
- 917 Plumbing
- 6.1K Radiant Heating
- 381 Solar
- 14.9K Strictly Steam
- 3.3K Thermostats and Controls
- 54 Water Quality
- 41 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements