Vintage American standard boiler parts

deadeye

blob:https://forum.heatinghelp.com/930ce098-cfc0-47b0-85d1-b77ab0665e31

looking for this American standard boiler part.

It’s a cast iron (tee) with a pump flange attached.

Please help

EdTheHeaterMan

Link not working

EdTheHeaterMan

Link not working. Is this the photo you were trying to display?

You may never find that fitting, but you can certainly make one with a couple of tee fittings and a pipe nipple.

What is in the boiler—a female tapping or a welded pipe nipple?

From what I can see here, you need to raise the circulator pump an inch or so to accommodate a 1-1/4" tee and a close nipple to a circulator flange.

On the third opening of the tee, you can add the 1/2" copper pipe and the drain valve using a bushing and a 1/2" tee fitting.

mattmia2

if that is just a nipple and some fittings threaded in the bottom i might try cutting out and replacing that first and see if resealing that fixes the problem.

EdTheHeaterMan

I found exactly what you are looking for

Some assembly required

Batteries not included