Quality vent/flue pipe source
Looking for some help with an ongoing issue that I have been having. And that is getting decent quality, snaplock vent/flue pipe, for boiler and water heater installations. Much of what I buy from various local suppliers, is out of round, or so rigid that it's murder to work with. I have many many years working with flue pipe, so this is not a lack of skill issue. And it's gone from bad to worse. I have been able to buy pretty good stuff from supplyhouse.com. Made by Pennco. But they are actually back ordered or out of stock. A local place in Queens / Brooklyn / Nassau County... would be lovely. Thanks in advance
Comments
-
I'd try McMaster Carr honestly.
https://www.mcmaster.com/products/duct/duct-and-fittings~/standard-duct-and-fittings~~/duct-and-fittings~component~duct/
Single pipe 392sqft system with an EG-40 rated for 325sqft and it's silent and balanced at all times.
1 -
Not local to you but Duc Pak in Mass. sells to supply houses and I think Southwark is in PA but has distribution all over. I would someone in NYC would carry Southwark stuff.
1 -
If there is a Winsupply nearby they should carry Southwark
1
Categories
- All Categories
- 87.4K THE MAIN WALL
- 3.3K A-C, Heat Pumps & Refrigeration
- 61 Biomass
- 430 Carbon Monoxide Awareness
- 121 Chimneys & Flues
- 2.1K Domestic Hot Water
- 5.9K Gas Heating
- 115 Geothermal
- 168 Indoor-Air Quality
- 3.8K Oil Heating
- 78 Pipe Deterioration
- 1K Plumbing
- 6.5K Radiant Heating
- 395 Solar
- 15.8K Strictly Steam
- 3.4K Thermostats and Controls
- 56 Water Quality
- 51 Industry Classes
- 50 Job Opportunities
- 18 Recall Announcements