Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
GE 29 gallon gas water heater
Options
ezzy1559
Member Posts: 1
I just installed a GE 29 gallon hot water heater when I light the pilot it lights and when I hold it for a 1 minute it stays lit but when I start to turn the knob when it reaches the almost the low setting it goes out. Please help me HVAC gods. Do I need to clean out the intake or do I need to replace a part what should I do. I have been taking cold water showers and I'm ready to stay home and not even go to work and maybe lose my job because I just can't handle it anymore I'm freezing and I'm feeling dirty. Please help me! Sincerely , COLD AND DESPERATE.
0
Comments
-
Is it the right water heater for the gas type?0
-
Hi, This might be a warranty problem. Call the manufacturer’s helpline and see what they have to say. It sounds like a bad control to me, but they should have a troubleshooting protocol for this.
Yours, Larry0
Categories
- All Categories
- 85.7K THE MAIN WALL
- 3K A-C, Heat Pumps & Refrigeration
- 49 Biomass
- 418 Carbon Monoxide Awareness
- 72 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 92 Geothermal
- 160 Indoor-Air Quality
- 3.2K Oil Heating
- 59 Pipe Deterioration
- 848 Plumbing
- 5.8K Radiant Heating
- 371 Solar
- 14.5K Strictly Steam
- 3.2K Thermostats and Controls
- 50 Water Quality
- 38 Industry Classes
- 47 Job Opportunities
- 15 Recall Announcements