Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

Waste of time and effort

SansAC
SansAC Member Posts: 2
edited September 2022 in Chimneys & Flues
< < < OP DELETED ORIGINAL POST > > >


Received no useful help here.

Comments

  • EBEBRATT-Ed
    EBEBRATT-Ed Member Posts: 17,466
    I think you need a good sheet metal guy. I would take the cap off and inspect the interior of the flue and make sure it is in good shape.

    I don't like the "Flat cap" the flue extends through. I would have a new cap made with some pitch to it. The new cap would have a sleeve welded or soldered to the new cap and then counter flashing put on the flue to cover that and I would extend the flue pipe up another foot or so and then put a new cap on the flue if you think the old one is no good
    109A_5HomerJSmithMikeAmann
  • SansAC
    SansAC Member Posts: 2
    edited September 2022
    < < < OP DELETED ORIGINAL POST > > >


    Received no useful help here.

Categories