Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
System 2000 ek1
Akwood94
Member Posts: 2
in Oil Heating
Have been having “no ignition” issues. Have replaced everything you can think of (cad cell, igniter module, control panel.) have had it serviced cleaned out and all. Still shows “no ignition” when it hardlocks after bout 10 cycles. It’s a repeated thing. Run for bout 10 cycles till it hardlocks and has to be reset again. Any ideas?
0
Comments
-
Call the service provider back and tell them the problem wasn't resolved on the first visit.
It seems oil related, like a suction leak or clogged line.
Where and what type of oil tank?
One pipe or two?0 -
Pressure switch0
-
Thank you for your post @Akwood94 , and for the good comments posted here as well.The below link can help your heating professional diagnose the issue, or please have them call our tech support line while they are working on your system.RogerPresident
Energy Kinetics, Inc.0 -
How's that for service?Retired and loving it.
2 -
Faster than the bat signal...DanHolohan said:How's that for service?
There was an error rendering this rich post.
1 -
Yeah.Retired and loving it.0
Categories
- All Categories
- 86.2K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 52 Biomass
- 422 Carbon Monoxide Awareness
- 90 Chimneys & Flues
- 2K Domestic Hot Water
- 5.4K Gas Heating
- 99 Geothermal
- 156 Indoor-Air Quality
- 3.4K Oil Heating
- 63 Pipe Deterioration
- 913 Plumbing
- 6K Radiant Heating
- 380 Solar
- 14.8K Strictly Steam
- 3.3K Thermostats and Controls
- 53 Water Quality
- 41 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements