Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

McDonnell Miller 67 Blow-down valve Handle??

jpf321
jpf321 Member Posts: 1,568
Does anyone in NYC have (that I can pick-up) or anyone else know, where to find a blow-down valve handle for an MM67 LWCO? Perhaps someone recently replaced a boiler and has a handle from an old unit?


1-pipe Homeowner - Queens, NYC

NEW: SlantFin Intrepid TR-30 + Tankless + Riello 40-F5 @ 0.85gph | OLD: Fitzgibbons 402 boiler + Beckett "SR" Oil Gun @ 1.75gph

installed: 0-20oz/si gauge | vaporstat | hour-meter | gortons on all rads | 1pc G#2 + 1pc G#1 on each of 2 mains

Connected EDR load: 371 sf venting load: 2.95cfm vent capacity: 4.62cfm
my NEW system pics | my OLD system pics

Comments

  • Fred
    Fred Member Posts: 8,542
    They are available everywhere. Check ebay and Supplyhouse.com
  • EBEBRATT-Ed
    EBEBRATT-Ed Member Posts: 15,513
    Not sure if you can by the handle separately. You may have to replace the whole thing
  • Fred
    Fred Member Posts: 8,542

    Not sure if you can by the handle separately. You may have to replace the whole thing

    They do sell the parts and handles separately.
  • EBEBRATT-Ed
    EBEBRATT-Ed Member Posts: 15,513
    good to know @Fred
  • JohnNY
    JohnNY Member Posts: 3,229
    It's McDonell-Miller part number 310447 and you can buy it at Pronto Gas Heating Supplies at 181 Chrystie St.
    Tell Tito I said hello.
    Contact John "JohnNY" Cataneo, NYC Master Plumber, Lic 1784
    Consulting & Troubleshooting
    Heating in NYC or NJ.
    Classes