Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
HELP. Weil McLain GV90+ 4 Flame LED Flashing, Low water temp
![kseering](https://secure.gravatar.com/avatar/1af07f58b324823b786f134c4b1d7917/?default=https%3A%2F%2Fvanillicon.com%2F081473e1e4478352c0be9f4ccfda5612_200.png&rating=g&size=200)
kseering
Member Posts: 4
Temp dial is set at 180 degrees. When temp gets to about 110 the Flame light flashes continuosly and the temp drops to 89 degrees. Temp never reaches near 180. The igniter was replaced, didn’t fix problem. 10 days ago a sensor temperature probe was replaced per a factory rep, apparently that wasn’t it.
A clip is attached.![](https://us.v-cdn.net/5021738/uploads/editor/66/z4zegop2s4nl.jpeg)
power light steady, tstat light steady, limit light steady, flame light flashes. Eventually they all go on and temp gets to about 110 and then we start all over again
Any ideas ??? We have had 3 attempts to correct this. Boiler was installed November 2016
A clip is attached.
![](https://us.v-cdn.net/5021738/uploads/editor/66/z4zegop2s4nl.jpeg)
power light steady, tstat light steady, limit light steady, flame light flashes. Eventually they all go on and temp gets to about 110 and then we start all over again
Any ideas ??? We have had 3 attempts to correct this. Boiler was installed November 2016
0
Categories
- All Categories
- 85.9K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 51 Biomass
- 420 Carbon Monoxide Awareness
- 78 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 94 Geothermal
- 154 Indoor-Air Quality
- 3.3K Oil Heating
- 59 Pipe Deterioration
- 883 Plumbing
- 5.9K Radiant Heating
- 377 Solar
- 14.6K Strictly Steam
- 3.2K Thermostats and Controls
- 51 Water Quality
- 40 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements