Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Steam zone valve

Snowmelt
Member Posts: 1,399
Other thread was getting long so I wanted to ask a comment on steam zone valve. My supply house said that the motor on the 4 inch was the wrong one because it didn’t supply enough torque to open the valve.
Then the original low voltage working wasn’t simplified. I asked on other post about it. But what I am thinking of doing is using a transformer and a taco S.R. 1 and just use the t t and the x x on the switching relay to close the circuit so I can physically see a light come on when calling for heat.
Does that make sence?
Then the original low voltage working wasn’t simplified. I asked on other post about it. But what I am thinking of doing is using a transformer and a taco S.R. 1 and just use the t t and the x x on the switching relay to close the circuit so I can physically see a light come on when calling for heat.
Does that make sence?
0
Categories
- All Categories
- 84.7K THE MAIN WALL
- 3K A-C, Heat Pumps & Refrigeration
- 54 Biomass
- 421 Carbon Monoxide Awareness
- 58 Chimneys & Flues
- 1.8K Domestic Hot Water
- 5K Gas Heating
- 124 Geothermal
- 158 Indoor-Air Quality
- 3.2K Oil Heating
- 57 Pipe Deterioration
- 830 Plumbing
- 5.6K Radiant Heating
- 373 Solar
- 14.3K Strictly Steam
- 3.1K Thermostats and Controls
- 55 Water Quality
- 42 Industry Classes
- 84 Job Opportunities
- 24 Recall Announcements