Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

3 days of Steam Class

Tinman
Tinman Member Posts: 2,808
edited February 2017 in Strictly Steam
I'm pretty excited about it.
Steve Minnich

Comments

  • Tinman
    Tinman Member Posts: 2,808
    edited February 2017
    The picture didn't load? It's at Bell & Gossett's Little Red Schoolhouse.
    Steve Minnich
  • EBEBRATT-Ed
    EBEBRATT-Ed Member Posts: 16,256
    edited February 2017
    Always wanted to go there. I didn't know they did steam as well. Some of my co-workers went a few years ago for the water systems
    Tinman
  • hvacfreak2
    hvacfreak2 Member Posts: 500
    I have been there a couple of times. Morton Grove , IL.

    They were fun and enlightening. Large Chilled Water Design was one class that was awesome. I had no need for a lot of it but I had a lot of fun. Advanced Hydronics was a good class . Make sure you hit them up for a System Syzer Wheel at a break.
    hvacfreak

    Mechanical Enthusiast

    Burnham MST 396 , 60 oz gauge , Tigerloop , Firomatic Check Valve , Mcdonnell Miller 67 lwco , Danfoss RA2k TRV's

    Easyio FG20 Controller

    Tinman
  • Tinman
    Tinman Member Posts: 2,808
    This is a heavy duty class. Most of what we've been taught so far has revolved around very high pressure systems, like 100 PSI and more. I'm understanding the details but missing out on the broad strokes a little bit. I'll have to fill in the blanks on my own time once it's over.
    Steve Minnich

Categories