Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
If our community has helped you, please consider making a contribution to support this website. Thanks!

Pump pressure ports

Options
Steve Minnich
Steve Minnich Member Posts: 2,868
in THE MAIN WALL
I would gladly pay a few extra bucks per pump to have these 1/8" tappings on every pump. We see a lot these Series 60's in the city and the gauge ports at the flanges are invaluable.
Steve Minnich
SWEI

Comments

  • Steamhead
    Steamhead Member Posts: 18,205
    Don't forget (2) isolation valves.
    All Steamed Up, Inc.
    Towson, MD, USA
    Steam, Vapor & Hot-Water Heating Specialists
    Oil & Gas Burner Service
    Consulting
    Steve Minnich
  • Steve Minnich
    Steve Minnich Member Posts: 2,868
    All these buildings that we've recently picked up for service have installations that were very, very good. It's a shame that the contractor had to close shop because their work was top notch. Isolation valves on all the pumps, pumping away, Lochinvar Knights, P/S done correctly, etc.

    And the hacks continue to Rip & Run.
    Steve Minnich
  • SWEI
    SWEI Member Posts: 7,348
    We use Webstone drain flanges on pretty much everything anyway. A set of MGHT x flare adapters and the Capsuhelic hooks right up.

Categories