Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Herman Nelson, Trane unit heater sizing
Options
Subtle Steam
Member Posts: 3
I am trying to locate BTU capacity, EDR, and/ or pounds condensate per hour on the
following steam fan forced unit heaters: Herman Nelson model TSU 1031 and a
round Trane model 100P. Both are at least 40-50 years old. The boiler pressure is about 5 psi. The Trane unit is round and the herman nelson is rectangular. Thank you in advance!
following steam fan forced unit heaters: Herman Nelson model TSU 1031 and a
round Trane model 100P. Both are at least 40-50 years old. The boiler pressure is about 5 psi. The Trane unit is round and the herman nelson is rectangular. Thank you in advance!
0
Comments
-
Good place to start
is here:
http://www.heatinghelp.com/article/172/Unit-Heaters/1403/Trane-unit-heaters
If you can't find anything else, go by the capacity of the steam pipe feeding the heater.All Steamed Up, Inc.
Towson, MD, USA
Steam, Vapor & Hot-Water Heating Specialists
Oil & Gas Burner Service
Consulting0
Categories
- All Categories
- 85.7K THE MAIN WALL
- 3K A-C, Heat Pumps & Refrigeration
- 51 Biomass
- 423 Carbon Monoxide Awareness
- 71 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 92 Geothermal
- 149 Indoor-Air Quality
- 3.2K Oil Heating
- 60 Pipe Deterioration
- 850 Plumbing
- 5.8K Radiant Heating
- 375 Solar
- 14.5K Strictly Steam
- 3.2K Thermostats and Controls
- 51 Water Quality
- 38 Industry Classes
- 55 Job Opportunities
- 18 Recall Announcements