Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
NYC consultant?
Travis_F
Member Posts: 14
I'm on the board of a pre-war, 70 unit, 6 floor coop, with single pipe steam. We are fans of Dan's book and have learned enough to know our system is a mess. We think we have ideas (again based on reading a few of the books) to improve efficiency, but are seeking a consultant to take a look at our system and offer additional suggestions or validate our ideas if they are good. Our super is great at installing new vents, so I don't think we need a full contractor, but rather someone who can help us come up with a plan to properly vent the system with our confusing mains, our four pressuretrols, and our 5psi pressure. If we could just spend half a day with someone, i think we'd be off to a great start. Suggestions?!
0
Comments
-
Consultant
J. Flato, 718 387 5291 / 917 363 0344 or Henry Gifford .0 -
NYC
I'll only go into New York for steam. We're available to help. You can find my info in my signature.0 -
I know a guy...
...And I am he.
See my company profile below or use the Find A Contractor feature at the top of the page for other options.Contact John "JohnNY" Cataneo, NYC Master Plumber, Lic 1784
Consulting & Troubleshooting
Heating in NYC or NJ.
Classes0
This discussion has been closed.
Categories
- All Categories
- 86.4K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 53 Biomass
- 423 Carbon Monoxide Awareness
- 92 Chimneys & Flues
- 2K Domestic Hot Water
- 5.4K Gas Heating
- 100 Geothermal
- 156 Indoor-Air Quality
- 3.4K Oil Heating
- 64 Pipe Deterioration
- 922 Plumbing
- 6.1K Radiant Heating
- 381 Solar
- 15K Strictly Steam
- 3.3K Thermostats and Controls
- 54 Water Quality
- 41 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements