Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Near boiler piping Knucklehead proof?
Options
Bio
Member Posts: 278
It doesnt get any easier to pipe a boiler, check attached, all pipes are already pre-measure, just go to hardware store with the list and half of the job is done
0
Comments
-
Crown is under the same ownership as Burnham
and Burnham sells such a kit for the MegaSteam.... does Crown sell this kit for their units? Some of those pipe lengths are not the standard pre-cut nipple lengths.......All Steamed Up, Inc.
Towson, MD, USA
Steam, Vapor & Hot-Water Heating Specialists
Oil & Gas Burner Service
Consulting0 -
No such thing
You can't make anything knucklehead-proof. Knuckleheads are too damn clever.Just another DIYer | King of Prussia, PA
1983(?) Peerless G-561-W-S | 3" drop header, CG400-1090, VXT-240 -
K-Heads:
Knuckleheads:
They're smart.
We're not.
As simple as that.0
This discussion has been closed.
Categories
- All Categories
- 85.2K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 55 Biomass
- 424 Carbon Monoxide Awareness
- 73 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 130 Geothermal
- 160 Indoor-Air Quality
- 3.3K Oil Heating
- 61 Pipe Deterioration
- 885 Plumbing
- 5.9K Radiant Heating
- 376 Solar
- 14.7K Strictly Steam
- 3.2K Thermostats and Controls
- 59 Water Quality
- 49 Industry Classes
- 89 Job Opportunities
- 28 Recall Announcements