Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Buderus GB142 cleaning - flashing error now
Mplsavant
Member Posts: 20
My heating guy cleaned my buderus today and it is getting a flashing CO on the BC10 controller....it went thru the chimney sweep cleaning and then flushed and then at next start up it was getting this message. Ideas guys?
0
Comments
-
Figured it out....
the pressure sensor was bad....the distributer said he sends out 5 to 10 a week on these.....hey Buderus, what about a recall?0
This discussion has been closed.
Categories
- All Categories
- 86K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 52 Biomass
- 421 Carbon Monoxide Awareness
- 81 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.3K Gas Heating
- 96 Geothermal
- 154 Indoor-Air Quality
- 3.3K Oil Heating
- 60 Pipe Deterioration
- 892 Plumbing
- 5.9K Radiant Heating
- 378 Solar
- 14.7K Strictly Steam
- 3.2K Thermostats and Controls
- 52 Water Quality
- 41 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements