Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Your Favorite Snowmelt Heat Exchanger?
JohnNY
Member Posts: 3,291
What are you guys using for a heat exchanger these days for glycol systems?
Contact John "JohnNY" Cataneo, NYC Master Plumber, Lic 1784
Consulting & Troubleshooting
Heating in NYC or NJ.
Classes
Consulting & Troubleshooting
Heating in NYC or NJ.
Classes
0
Comments
-
I like Taco.
I use the Taco HX's. They are readily available. Their performance charts are solid and I haven't had any problems.
Just pay attention to your required flow rates when sizing. That will help you decide whether to use a brazed plate, plate and frame, or tube and shell design.
http://www.taco-hvac.com/en/products/Heat%20Transfer%20Products/products.html?current_category=24
Good Luck0 -
Taco X Block
Works great providing it can deliver the load.There was an error rendering this rich post.
0
This discussion has been closed.
Categories
- All Categories
- 86.3K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 53 Biomass
- 422 Carbon Monoxide Awareness
- 90 Chimneys & Flues
- 2K Domestic Hot Water
- 5.4K Gas Heating
- 100 Geothermal
- 156 Indoor-Air Quality
- 3.4K Oil Heating
- 63 Pipe Deterioration
- 916 Plumbing
- 6K Radiant Heating
- 381 Solar
- 14.9K Strictly Steam
- 3.3K Thermostats and Controls
- 54 Water Quality
- 41 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements