Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Insulating Steam Header
NickM
Member Posts: 25
The header on my WM 88 series 9 section has no insulation
The pipe is 8.5" OD, about 7 feet long
What would be the best way to insulate it --- I can not find material like a fiberglass shell.
Regards
Nick
The pipe is 8.5" OD, about 7 feet long
What would be the best way to insulate it --- I can not find material like a fiberglass shell.
Regards
Nick
0
Comments
-
Insulation
Here are two examples Nick, do it yourself and professional. http://www.heatinghelp.com/forum-thread/132995/What-type-of-pipe-insulation-should-be-used-on-the-near-boiler-piping0 -
Will start this weekend
Thanks for the heads up
All you guys are great0 -
8" Pipe Size Fiberglass Insulation
If the OD is 8.5" you have a pipe that has an 8" Nominal Pipe Size. They make 8 x whatever thickness fiberglass you need and come in 3ft lon sections that would snap right on.There was an error rendering this rich post.
0
This discussion has been closed.
Categories
- All Categories
- 86.3K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 53 Biomass
- 422 Carbon Monoxide Awareness
- 90 Chimneys & Flues
- 2K Domestic Hot Water
- 5.4K Gas Heating
- 100 Geothermal
- 156 Indoor-Air Quality
- 3.4K Oil Heating
- 63 Pipe Deterioration
- 916 Plumbing
- 6K Radiant Heating
- 381 Solar
- 14.9K Strictly Steam
- 3.3K Thermostats and Controls
- 54 Water Quality
- 41 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements