LWCO

ottawan

I need a new LWCO (Mcdonnell & Miller , #341600, strainer, valve etc kit) and I see I can buy it on-line from Radwell International for $186. Is installation (apart from the piping) just a matter of putting it back in as it was or are there fine adjustments to be made to ensure proper operation once it's in? That is, could a DYI type who has done some copper piping handle this?

TomM

use the force

not sure which model u have:

http://www.mcdonnellmiller.com/MM-Installation-Instructions.asp

ottawan

Model Number

Tom



I've attached a few pictures of the part and a label on the piece above it showing the model number of the whole control (I think). Hope this helps.

jpf321

you may want to look...

at StateSupply.com as well for MM repair parts. http://www.statesupply.com/displayCategory.do?Id=765



Make sure that you get the necessary gaskets if applicable.

ottawan

Parts

Thanks for the tip on Stateside. Nicely organized site.