Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Good label maker

Big Will
Member Posts: 395
I have a Brady ID pal. It works OK jams sometimes sometimes the printing has voids. The real problem is the cost of the labels. I love a well labeled mech. room. what do you all use.
0
Comments
-
An old-school Dymo
never failed me yet.All Steamed Up, Inc.
Towson, MD, USA
Steam, Vapor & Hot-Water Heating Specialists
Oil & Gas Burner Service
Consulting0 -
They are bulitproof
they are really slow though. For instance I have to label control wires a lot. In the project we are doing now their are over 200 labels that need to start with MHCOR Followed by three digits. I think I might by the dymno for the smaller mech rooms were I only need a dozen or so labels.0
This discussion has been closed.
Categories
- All Categories
- 86.9K THE MAIN WALL
- 3.2K A-C, Heat Pumps & Refrigeration
- 57 Biomass
- 425 Carbon Monoxide Awareness
- 109 Chimneys & Flues
- 2.1K Domestic Hot Water
- 5.7K Gas Heating
- 105 Geothermal
- 160 Indoor-Air Quality
- 3.6K Oil Heating
- 70 Pipe Deterioration
- 971 Plumbing
- 6.3K Radiant Heating
- 386 Solar
- 15.4K Strictly Steam
- 3.4K Thermostats and Controls
- 54 Water Quality
- 44 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements