Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Controls Suggestion
Options

MechTech_2
Member Posts: 84
I'm trying to figure out my best control strategy for attached drawing, which includes simultaneous geothermal heating and cooling, air handlers, radiant floors, pool, boiler, dhw and de-superheater. Any experience and/or suggestions would be greatly appreciated. Any comments or suggestions on the near boiler design would also be welcome.
0
Comments
-
Uponor Climate Control - Network System
take a look at the attached. very similar operation except most of the house was RFHDave Holdorf
Technical Training Manager - East
Taco, Inc
0 -
CCN
Will Uponor custom write the application, or is this part of the canned offering?
Peter
Formerly Uponor & Plasco(RTI)
P.S. I missed my DHW pump0 -
CCN
Most of this is already written into the code or has been done in the past, so if custom is needed, a "cut and paste" is all that may be needed.
Dave Holdorf
Uponor East Field Tech
(former RTI Engineer/Designer/Tech Support/........)Dave Holdorf
Technical Training Manager - East
Taco, Inc
0
This discussion has been closed.
Categories
- All Categories
- 87K THE MAIN WALL
- 3.2K A-C, Heat Pumps & Refrigeration
- 57 Biomass
- 425 Carbon Monoxide Awareness
- 112 Chimneys & Flues
- 2.1K Domestic Hot Water
- 5.7K Gas Heating
- 106 Geothermal
- 160 Indoor-Air Quality
- 3.6K Oil Heating
- 70 Pipe Deterioration
- 980 Plumbing
- 6.3K Radiant Heating
- 388 Solar
- 15.4K Strictly Steam
- 3.4K Thermostats and Controls
- 54 Water Quality
- 44 Industry Classes
- 48 Job Opportunities
- 18 Recall Announcements