Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
internal wrench
Options
Brian_74
Member Posts: 237
To remove and to install a steam trap union nut nipple am I right in thinking that I'll need an internal pipe wrench? If I do, any opinions about which style is the best?
There was an error rendering this rich post.
0
Comments
-
The third one is the kind I use
The middle is used for toilets and urinal spuds, and the first is used for small pipe nipples. Like Shower head arms.Cost is what you spend , value is what you get.
cell # 413-841-6726
https://heatinghelp.com/find-a-contractor/detail/charles-garrity-plumbing-and-heating0 -
For once I don't need the most expensive tool!
Thanks, Charlie, for clarifying which is which. I do need one for trap installation and removal, then, don't I?There was an error rendering this rich post.
0
This discussion has been closed.
Categories
- All Categories
- 85.7K THE MAIN WALL
- 3K A-C, Heat Pumps & Refrigeration
- 49 Biomass
- 424 Carbon Monoxide Awareness
- 71 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 92 Geothermal
- 149 Indoor-Air Quality
- 3.2K Oil Heating
- 59 Pipe Deterioration
- 847 Plumbing
- 5.8K Radiant Heating
- 371 Solar
- 14.5K Strictly Steam
- 3.2K Thermostats and Controls
- 50 Water Quality
- 38 Industry Classes
- 47 Job Opportunities
- 15 Recall Announcements