Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Source for "ceramic" insulation for Dunkirk boiler?
Options
Al Roethlisberger
Member Posts: 194
I have a PWB8-D Dunkirk boiler and during my cleaning I noticed that the "ceramic"(appears) felt gasket between the iron sections and sheet metal hood is severely deteriorated. It appears to just be four individual inch wide by about 1/4" think strips of insulation laid atop the cast iron sections.
Is there a source for the manufacturers gasket or an appropriate aftermarket source for the material?
Thanks,
Al
Is there a source for the manufacturers gasket or an appropriate aftermarket source for the material?
Thanks,
Al
There was an error rendering this rich post.
0
Comments
-
I'd use
furnace cement or hi-temp silicone.All Steamed Up, Inc.
Towson, MD, USA
Steam, Vapor & Hot-Water Heating Specialists
Oil & Gas Burner Service
Consulting0
This discussion has been closed.
Categories
- All Categories
- 85.7K THE MAIN WALL
- 3K A-C, Heat Pumps & Refrigeration
- 49 Biomass
- 418 Carbon Monoxide Awareness
- 73 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 92 Geothermal
- 150 Indoor-Air Quality
- 3.2K Oil Heating
- 59 Pipe Deterioration
- 850 Plumbing
- 5.8K Radiant Heating
- 372 Solar
- 14.5K Strictly Steam
- 3.2K Thermostats and Controls
- 50 Water Quality
- 39 Industry Classes
- 47 Job Opportunities
- 15 Recall Announcements